After the autumn harvest is completed, the dirt, crushed straw, grains, and other debris inside and outside the harvester must be cleaned in a timely manner, and rinsed with water for 1-2 times, dried and then stored in the hangar. At the same time, the fuselage needs to be covered with a thick film to prevent dust from entering. Disassemble all the triangular belts, wipe them clean, apply talcum powder, install them in plastic bags, and hang them on the wall inside the warehouse; remove the transmission chain and put them into diesel to clean them up, coat them with oil, and wrap them with plastic paper. it is good. Inspection should be carried out to comprehensively check the wear parts on the harvester, such as the movable blade and fixed blade on the cutting table, the auger telescopic rod sleeve, and the roller nails. Derusting Add grease to the rotating bearings on each component. Apply oil or grease to the friction parts, such as cutters, clutch claws, auger extension rods, adjusting bolts, etc., to prevent corrosion. Place the wood on the pad to lift the harvester off the ground, lower the header and reel to the lowest position, and place it on the pad stably, so that the lifting handle of the hydraulic lifting system is placed in the descending position. Battery Storage Remove the battery and store it separately. After the battery is fully charged, pour out the electrolyte, change into distilled water, park for 6 hours, recharge for 4 hours, replace distilled water and then charge for 2 hours, then pour out distilled water, and then fill with fresh distilled water to store it for a long period of time. Pay attention to heat preservation and antifreeze; also fully discharge the battery, pour out the electrolyte and rinse it with distilled water several times, until the water is not acidic, then pour distilled water, dry, tighten the hole cover, seal the vent hole, and then long-term storage. After the engine has been sampled and sealed, crank the crankshaft more than two times by hand each month and inject a small amount of clean oil into the cylinder. Turn the hydraulic lift handle back and forth 10 to 20 times to maintain flexibility. Needle Counter,Needle Counter Box,Medical Needle Counter,Plastic Needle Counter ShaoXing SurgeCare Medical Products Co., Ltd. , https://www.sxsurgecaremedical.com
Headlights and fuel tank protection The generators, lighting headlights and other major electrical devices should be removed and wiped clean, and kept separately to prevent damage. Open the engine water tank, body, etc., turn on the water switch, put clean water; release the fuel in the fuel tank; wrap the air filter, exhaust port, fuel tank filler port, etc. with plastic cloth; inject proper amount into the cylinder. Clean the oil and turn the crankshaft several turns.
Rice harvester winter maintenance pay attention
Maintaining the performance of the agricultural machinery and Changxin, it is essential to do scientific maintenance in winter. After the end of the harvest operation, we must do a scientific and timely job in the maintenance and storage of rice harvesters.