Operation process and maintenance of superfine pulverizer

1. Check if there is oil in the lubrication area before starting the machine.

2. Remove metal, sand, stone and other debris from the material to prevent damage to the machine.

3. The hand should not reach into the feeding port, and the cover should not be opened during operation.

4, the sieve aperture should be properly selected, the damage should be riveted.

5. It is forbidden to start the load. The machine runs for one minute and then feeds evenly. When the pulp is used, it is filled with water.

6. Empty the machine for 2 minutes before stopping.

Superfine grinder adjustment and maintenance

1. The main wearing parts of the crusher: flat teeth, round teeth, large and small grinding teeth. The flat teeth and the scalloped steel are processed, the dynamic balance is good, and the serious wear should be replaced. The size of the self-made gold processing should be no more than 1 gram per piece to avoid vibration damage to the bearing and the machine.

2, 0.6-12 mm various specifications of the sieve. When replacing, you need to face down.

3, the bearing is regularly filled with high-speed butter, check once every half month, and when it is found to be seriously worn, it should be replaced or repaired in time.

4. It is strictly forbidden to collide. It should be cleaned inside and outside for a long time, and kept safely to prevent rust.

5, for all reasons of manufacturing and can not work properly, users can directly with the manufacturer, free warranty.

Superfine grinder considerations

1. The operator should stand on the side of the feeding port, the hand should not be allowed to extend into the material inlet, and the machine cover should not be opened during operation and the machine is not stopped.

2. It is forbidden to start the load. When the feeding port is blocked, it is forbidden to forcibly feed by hand or wooden stick, and should be stopped immediately for inspection. When working, apply a proper amount of uniform feeding. If there is a semi-wet material, dry it, or reduce the amount of feeding.

Superfine grinder machine maintenance and storage

1. Always check the fastening of each component to prevent it from loosening and damage the machine.

2. The oil filling holes should be refueled frequently, and the bearing parts should be cleaned and filled with lithium-based grease every six months.

3. When the machine is shut down, the machine should be idling for a period of time, and the remaining material in the machine should be blown off before shutting down.

4. When the machine is deactivated, the external debris should be removed, and all the rotating parts should be greased and stored in the air-dry, non-corrosive gas warehouse.