Wiggle wire lock is designed to be used with poly lock base cap- sold separately. Greenhouse wiggle wire and base care are an effective method of attaching your poly film roof and or shade cloth. The greenhouse wiggle wire lock will hold form 4 mil to 20 mil thickness of material. Use one wire to hold the roof in place and then add a second wire to hold your shade cloth. When it is time to remove the shade cloth, you will not disturb the roof plastic. Greenhouse Wiggle Wire,Greenhouse Steel Wire,Greenhouse Spring Wire JIANGSU SKYPLAN GREENHOUSE TECHNOLOGY CO.,LTD , https://www.greenhousehydroponic.com
1. Check the cause of the malfunction. If the vacuum pump does not work, there are three reasons: First, it is possible that the travel switch is not depressed, the cover can be closed, or the position of the pressure screw can be adjusted to adjust the travel switch. It is electrically controlled and requires adjustment of the lever. Second, if the vacuum packaging machine uses a relay control panel, the vacuum pump motor may be damaged and can be directly repaired or replaced by the manufacturer. Third, if the food vacuum packaging machine adopts the computer version control, the failure of the pumping system is that the computer board is damaged and needs to be repaired or replaced.
2. The vacuum packaging machine does not reach the set vacuum, which is another common problem. The vacuum pump is used to control the vacuum. If the pump is damaged, the vacuuming work cannot be carried out smoothly. In addition, hardware problems such as looseness of the pipe joint, rupture of the pipe, damage to the seal of the vacuum chamber, damage to the solenoid valve, etc., will affect the degree of vacuum. There is also a man-made problem that is easily overlooked, that is, the oil in the vacuum pump is insufficient and the pumping time is insufficient.
3. If the vacuum chamber is not opened after a working cycle is completed, it is very likely that the venting solenoid valve is not opened after the working cycle is completed, resulting in excessive pressure difference. The cover of the large continuous vacuum packaging machine is electrically opened, and the motor cannot be opened normally if it is damaged.
4. If there is a lot of air left in the bag, the place to check is whether the sealing strip is reset normally, causing the bag to be pressed when the vacuum packaging machine is pumping, and the air can not be smoothly taken out in advance; or there may be a sealing strip Inflexible, the mouth of the bag is crushed, so that the air cannot be extracted.
Universal Base (WIG2000)- used on the curved surface, i.e. the arch for attaching the end wall covering.
Standard Base (WIG1000) - used along the straight lengths of your greenhouse.
How to solve the problem of the vacuum packaging machine pumping system
The pumping system of the vacuum packaging machine is the key to the entire packaging work, which directly determines whether the packaging can achieve qualified vacuum packaging and achieve the desired shelf life, which is especially important in the food packaging industry. If the food vacuum packaging equipment has a pumping failure, do not tamper with it, you should follow the following methods:
Next Article
Which foods can sunscreen
Prev Article
Hunan tomato (tomato) fertilizer application