K-type reciprocating feeder (feeder) is a complete working coal feeder (reciprocating feeding) consisting of connecting crank shell, bottom tug, coupling, coal feeder floor and other parts. machine). The coal feeder is driven by the manufacturer and finally arrives at the designated place after long journey. In the early stage of installation and long-term operation, we need to use it properly and maintain it to achieve long-term normal operation benefits. Pay attention to the following points: Protecting Liver Plant Extract,Silymarin Powder,Silymarin Extract,Silymarin Extract Powder Youth Biotech CO,. Ltd. , https://www.youtherb.com
Use and maintenance:
1, K type reciprocating space required to install the load after the test coal for 2 hours rolling bearing temperature not greater than 600C.
2. When adjusting the feeding capacity, pull out the pin of the crank part, loosen the nut and turn the crank; the transmission parts and reducer should be cleaned and cleaned the rolling bearing and the box after 6 months of continuous operation, and the worn parts are replaced.
3. Select the fixed position of the crank case "1, 2, 3, 4", insert the pin, and tighten the pin and nut.
4. When the coal feeder is in operation, sufficient coal quantity should be stored in the coal bunker to avoid direct impact on the bottom plate when the coal is put into the warehouse; the liner directly rubbed by the machine and the coal should be replaced when the thickness is more than half of the wear.
5. The transmission parts and reducer should be cleaned and cleaned after 6 months of continuous operation to clean the rolling bearing and the box, replace the worn parts, and the motor and reducer are carried out according to the maintenance requirements.
K-type reciprocating feeder (feeder) models are: k0, K1, K2, K3, K4 type, the larger the model, the larger the motor power, but the use and maintenance are the same, please remember in use .
K-type reciprocating feeder (feeder) for proper use and maintenance