Constant temperature water bath maintenance: Arm Portable CMM Arm Portable CMM Automated Precision Inc. , https://www.apiasean.com
1. Clean the instrument immediately after each use.
2. After each use, the water in the constant temperature water bath is cleaned, and the coarse impurities in the constant temperature water bath are lightly brushed off with a brush, and the pot is removed. Wipe the inner and outer surfaces of the constant temperature water bath with a soft cloth, and then dry with a cleaning cloth.
3. Effect evaluation: The inner surface of the device should be free of water, and the outer surface of the device should be bright and tidy, without smudging.
4. When the constant temperature water bath is used, it must be grounded reliably, and the water should not overflow into the control box.
5. Do not use water or water level below the electric heating tube in the constant temperature water bath to prevent the electric heating tube from being damaged.
6. Perform maintenance inspection of the instrument once a month and fill in the maintenance record in time.
Constant temperature water bath application areas:
The constant temperature and constant temperature water bath is widely used in drying, concentrating, distilling, impregnating chemical reagents, impregnating drugs and biological products, and can also be used for constant temperature heating and other temperature tests in water baths. It is a biological, genetic, viral, aquatic, environmental, medical, health, and biochemical experiment. Room, education and scientific research essential tools Stainless steel constant temperature water bath is the medical unit, colleges and universities, scientific research and environmental protection, petrochemical, printing and dyeing, factory and other industries, the laboratory to do distillation, drying, concentration and constant temperature heating of chemicals and biological drugs must Preparation tools.
A stainless steel tubular heater is placed horizontally in a constant temperature water bath, and an aluminum shelf with a hole is placed inside the sink. The upper cover is equipped with a combination of different calibers to accommodate flasks of different calibers. There is a water discharge pipe on the left side of the constant temperature water bath. The right side of the constant temperature water bath is an electric box. The front panel of the electric box is equipped with a temperature control meter and a power switch.
Operation and use of water bath>
Next Article
The control measures of wilt disease of leeks
Prev Article
White monkshood nutrition knowledge