Round bottle labeling machine repair tips

The round bottle labeling machine is a relatively common labeling machine, which is mainly used in the automatic labeling of various cylindrical bottles for medicinal, daily chemical and food. It adopts adjustable bottle dividing device and high-precision and high-speed labeling device to adapt to product labeling in various sizes.

In daily use, it will inevitably encounter some minor problems. Today, Xiaobian introduces several repair tips for round bottle labeling machines:

1. The three factors of the bottom paper break and the quality of the label backing paper, the scratching of the labeling path, and the label sticking are closely related.

(1) Check if the bottom paper is chopped. If the bottom paper is cut, you need to replace the quality quality paper. It is recommended to use Glassine paper and the label supplier is required to control the die cutting depth and not to damage the paper.

(2) Check the label for any scratches in the bypass and eliminate the scratching factor.

(3) If the label is stuck, the label is easily torn. Control the next bid length to ensure that it does not stick to the labeled product.

2. The deviation exceeds 2mm, the label deviation and the deviation of the label, the direction of the label and the direction of product transportation are not parallel, the traction wheel slips, the product positioning detection is not allowed, the label is not attached to the product along the labeling roller, and several factors of product error Related, check the above factors, and then solve the problem.

(1) The belt is biased, the traction mechanism is relaxed, and the label is pulled back and forth to let it automatically go straight. After the label is positive, clamp the limit ring on both sides and guide the label.

(2) The direction of the label is not parallel to the direction of product transport, and parallel can be achieved by adjusting the inclination of the labeling head.

(3) The traction wheel is slipping, the traction wheel is worn, and the traction wheel locking screw is loose. For both reasons, the traction wheel locking screw can be tightened.

(4) Product error, during the production process, the edge error will cause labeling deviation, which can only be solved by controlling the product quality.

3. Continuous bidding and continuous bidding are not completely related to the sensitivity of the electric eye detection, and the sensitivity can be adjusted. For the adjustment method, please refer to the previous electric eye adjustment chapter.

(1) If the adjustment of the electric eye can not be solved, the label may be out of the applicable range of the selected electric eye, or the electric eye is damaged, and the manufacturer may be consulted.

(2) Another reason is that the label is deflected, the label is not detected by the electric eye, and the electric eye can be adjusted to the detection position before and after. The bottom paper at the board is slack

(3) The slack of the bottom paper and the low traction speed are related to the slippage of the traction mechanism. If the traction speed is too low, the traction speed can be solved;

(4) If the traction mechanism is slipping, tighten the locking screw of the traction roller until the bottom paper does not slip. (5) Also, pay attention to whether the drive belt behind the receiving shaft is broken.